| 2 |
|
Basilisk II |
| 3 |
|
A 68k Macintosh emulator |
| 4 |
|
|
| 5 |
< |
Copyright (C) 1997-2003 Christian Bauer et al. |
| 5 |
> |
Copyright (C) 1997-2008 Christian Bauer et al. |
| 6 |
|
|
| 7 |
|
|
| 8 |
|
License |
| 26 |
|
IRIX 6.5) |
| 27 |
|
- AmigaOS 3.x |
| 28 |
|
- Windows NT 4.0 (mostly works under Windows 95/98, too) |
| 29 |
< |
- Mac OS X 10.1, 10.2 |
| 29 |
> |
- Mac OS X 10.1 thru 10.4 |
| 30 |
|
|
| 31 |
|
Some features of Basilisk II: |
| 32 |
|
- Emulates either a Mac Classic (which runs MacOS 0.x thru 7.5) |
| 362 |
|
|
| 363 |
|
Linux: |
| 364 |
|
The "ethernet card description" is the name of an Ethernet interface. |
| 365 |
< |
There are two approaches to networking with Basilisk II: |
| 365 |
> |
There are four approaches to networking with Basilisk II: |
| 366 |
|
|
| 367 |
|
1. Direct access to an Ethernet card via the "sheep_net" kernel module. |
| 368 |
|
The "ethernet card description" must be the name of a real Ethernet |
| 432 |
|
your network administrator about the nets and zones you can use |
| 433 |
|
(instead of the ones given in the example above). |
| 434 |
|
|
| 435 |
+ |
3. Access the network through a "tuntap" interface. |
| 436 |
+ |
The "ethernet card description" must be set to "tun". |
| 437 |
+ |
|
| 438 |
+ |
TUN/TAP provides packet reception and transmission for user |
| 439 |
+ |
space programs. It can be viewed as a simple Point-to-Point |
| 440 |
+ |
or Ethernet device, which instead of receiving packets from a |
| 441 |
+ |
physical media, receives them from user space program and |
| 442 |
+ |
instead of sending packets via physical media writes them to |
| 443 |
+ |
the user space program. |
| 444 |
+ |
|
| 445 |
+ |
Prerequesties: |
| 446 |
+ |
- Make sure the "tun" kernel module is loaded |
| 447 |
+ |
# modprobe tun |
| 448 |
+ |
- Make sure IP Fordwarding is enabled on your system |
| 449 |
+ |
# echo 1 >/proc/sys/net/ipv4/ip_forward |
| 450 |
+ |
|
| 451 |
+ |
A virtual network configuration script is required and the |
| 452 |
+ |
default is /usr/local/BasiliskII/tunconfig unless you specify |
| 453 |
+ |
a different file with the "etherconfig" item. |
| 454 |
+ |
|
| 455 |
+ |
This script requires you that "sudo" is properly configured |
| 456 |
+ |
so that "/sbin/ifconfig" and "/sbin/iptables" can be executed |
| 457 |
+ |
as root. Otherwise, you can still write a helper script which |
| 458 |
+ |
invokes your favorite program to enhance a user priviledges. |
| 459 |
+ |
e.g. in a KDE environment, kdesu can be used as follows: |
| 460 |
+ |
|
| 461 |
+ |
#!/bin/sh |
| 462 |
+ |
exec /usr/bin/kdesu -c /path/to/tunconfig $1 $2 |
| 463 |
+ |
|
| 464 |
+ |
4. Access the network through the user mode network stack. |
| 465 |
+ |
(the code and this documentation come from QEMU) |
| 466 |
+ |
|
| 467 |
+ |
By setting the "ethernet card description" to "slirp", |
| 468 |
+ |
Basilisk II uses a completely user mode network stack (you |
| 469 |
+ |
don't need root priviledges to use the virtual network). The |
| 470 |
+ |
virtual network configuration is the following: |
| 471 |
+ |
|
| 472 |
+ |
Basilisk II <------> Firewall/DHCP server <-----> Internet |
| 473 |
+ |
(10.0.2.x) | (10.0.2.2) |
| 474 |
+ |
| |
| 475 |
+ |
----> DNS server (10.0.2.3) |
| 476 |
+ |
| |
| 477 |
+ |
----> SMB server (10.0.2.4) |
| 478 |
+ |
|
| 479 |
+ |
Basilisk II behaves as if it was behind a firewall which |
| 480 |
+ |
blocks all incoming connections. You can use a DHCP client to |
| 481 |
+ |
automatically configure the network in Basilisk II. |
| 482 |
+ |
|
| 483 |
+ |
In order to check that the user mode network is working, you |
| 484 |
+ |
can ping the address 10.0.2.2 and verify that you got an |
| 485 |
+ |
address in the range 10.0.2.x from the Basilisk II virtual |
| 486 |
+ |
DHCP server. |
| 487 |
+ |
|
| 488 |
+ |
Note that ping is not supported reliably to the internet as |
| 489 |
+ |
it would require root priviledges. It means you can only ping |
| 490 |
+ |
the local router (10.0.2.2). |
| 491 |
+ |
|
| 492 |
+ |
When using the built-in TFTP server, the router is also the |
| 493 |
+ |
TFTP server. |
| 494 |
+ |
|
| 495 |
|
FreeBSD: |
| 496 |
|
The "ethertap" method described above also works under FreeBSD, but since |
| 497 |
|
no-one has found the time to write a section for this manual, you're on |
| 504 |
|
not an Ethernet device, Basilisk II will display a warning message and |
| 505 |
|
disable Ethernet networking. |
| 506 |
|
|
| 507 |
+ |
Mac OS X: |
| 508 |
+ |
The "slirp" method described above now seems to work. |
| 509 |
+ |
|
| 510 |
+ |
|
| 511 |
|
See the next item for an alternative way to do networking with Basilisk II. |
| 512 |
|
|
| 513 |
|
udptunnel <"true" or "false"> |
| 588 |
|
error alerts. All errors will then be reported to stdout. The default |
| 589 |
|
is "false". |
| 590 |
|
|
| 591 |
+ |
keyboardtype <keyboard-id> |
| 592 |
+ |
|
| 593 |
+ |
Specifies the keyboard type that BasiliskII should report to the MacOS. |
| 594 |
+ |
The default is "5" which is a "Apple Extended Keyboard II (ISO)", |
| 595 |
+ |
but many other numbers are understood by most versions of the MacOS |
| 596 |
+ |
(e.g. 11 is a "Macintosh Plus Keyboard with keypad", |
| 597 |
+ |
13 is a "Apple PowerBook Keyboard (ISO)" ) |
| 598 |
+ |
|
| 599 |
|
For additional information, consult the source. |
| 600 |
|
|
| 601 |
|
|
| 902 |
|
- Nigel Pearson <nigel@ind.tansu.com.au>: Mac OS X port |
| 903 |
|
- Lauri Pesonen <lpesonen@nic.fi>: Windows NT port |
| 904 |
|
- Bernd Schmidt <crux@pool.informatik.rwth-aachen.de>: UAE 68k emulation |
| 905 |
+ |
- Michael Z. Sliczniak <msliczniak@comcast.net>: Mach memory fault recovery |
| 906 |
|
- and others... |
| 907 |
|
|
| 908 |
|
Special thanks to: |
| 980 |
|
http://lists.sourceforge.net/lists/listinfo/basilisk-devel |
| 981 |
|
|
| 982 |
|
Some general advice about asking technical support questions can be found at |
| 983 |
< |
http://www.tuxedo.org/~esr/faqs/smart-questions.html |
| 983 |
> |
http://www.catb.org/~esr/faqs/smart-questions.html |
| 984 |
|
|
| 985 |
|
Keeping this in mind will greatly increase your chances of getting a useful |
| 986 |
|
answer. |
